User's Guide

17 September 2021

NG Series Industrial Wireless Gateway User Guide

DIVIGRAPH

Doc No. 20DD1980

Revision 4

Introduction

Description

The NG Series Industrial Wireless Gateway provides ISA100 gateway and back bone router (BBR)

functionality to communicate with VP Series 2000 ISA100 field devices. To enhance security, the devices

use 128-bit AES encrypted packets.

If a gateway cannot communicate with ISA100 VP Series 2000 sensors that are out of range, you can use

VP Series 2000 ISA100 repeaters to extend your ISA100 network.

NG Series Industrial Wireless Gateways are intended for monitoring purposes only and should not be used

in control or safety systems.

Compliance Information

This device complies with part 15 of the FCC Rules and contains license-exempt transmitter(s)/receiver(s)

that comply with Innovation, Science and Economic Development Canada's license-exempt RSS(s).

Operation is subject to the following conditions:

• This device may not cause harmful interference.

• This device must accept any interference received, including interference that may cause undesired

operation.

Changes or modifications not approved by the responsible party could void the user's authority to operate

the equipment.

This radio transmitter (ISED: 23417-NG01) has been approved by Innovation, Science and Economic

Development Canada to operate with the antenna types listed below (Table 1), with the maximum

permissible gain indicated. Antenna types not included in this list that have a gain greater than the

maximum gain indicated for any type listed are strictly prohibited for use with this device.

Table 1: NG Series Industrial Wireless Gateway Authorized Antennas

Antenna Part Number

Type and Gain (dBi)

100A1001

Omnidirectional 2dBi

100A1002

Omnidirectional 6dBi

Note: This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.