User's Guide
Table Of Contents
- 1 Introduction
- 2 References
- 3 Terms and Definitions
- 4 Support
- 5 Hazardous Location Requirements
- 6 Operating Conditions
- 7 General Safety
- 8 Radio and Electromagnetic Compatibility
- 9 VP Series 2000 Components
- 10 ISA100.11a Provisioning
- 11 Hardware Installation
- 12 Configuration
- 13 Operation
- 14 Maintenance
- 15 Security Hardening Guidelines
EVR-VPXDOC-0036 VP Series 2000 User Guide
Version 1.09
Proprietary & Confidential - Copyright © 2018 Divigraph (Pty) Ltd. All Rights Reserved
Page 23 / 36
10.3 ISA100.11a OTA Provisioning
The OTA provisioning process allows for devices to be provisioned directly from the network
infrastructure gateway. Refer to the network infrastructure vendor documentation for additional
information about how to provision devices using this method. The following steps outline the OTA
provisioning process:
• Configure the network infrastructure as per the vendor documentation.
• Power up the VP Series 2000 nodes to be provisioned.
• Enable the network infrastructure provisioning network.
• Provision VP Series 2000 devices using OTA provisioning
Note!
If OTA provisioning fails, the VP Series 2000 software and node docking station may be
required to reset the device to an unprovisioned state.
10.4 Unprovisioning
VP Series 2000 devices can be unprovisioned using the VP Series 2000 Software and Node Docking
Station.
Refer to the VP Series 2000 Software User Guide for additional information.
Refer to the relevant network infrastructure documentation for information on how to unprovision
devices from the wireless sensor network gateway.