User's Guide
Table Of Contents
- 1 Introduction
- 2 References
- 3 Terms and Definitions
- 4 Support
- 5 Hazardous Location Requirements
- 6 Operating Conditions
- 7 General Safety
- 8 Radio and Electromagnetic Compatibility
- 9 VP Series 2000 Components
- 10 ISA100.11a Provisioning
- 11 Hardware Installation
- 12 Configuration
- 13 Operation
- 14 Maintenance
- 15 Security Hardening Guidelines
EVR-VPXDOC-0036 VP Series 2000 User Guide
Version 1.09
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved
Page 18 / 36
9.2 Electrical Cells
A Lithium primary cell powers the VP Series 2000 sensors and repeaters. As such, applicable
precautions should be taken when installing, operating and maintaining these products.
Figure 2 - Cell - Xeno XL-205F
Figure 3 - Cell - Tadiran TL-5930
Lithium cells are not provided with the product and it is the responsibility of the end-user to source
and use only approved cells. The only cells approved:
• Tadiran SL-2780
• Tadiran TL-5930
• Tadiran TLH-5930
• Xeno XL205-F
Warning!
Use of any cell other than the models listed in the product data sheet will void the product
hazardous area certification.
Use of any cell other than the type listed may present a significant safety hazard.
Note!
Use of any cell other than the type listed in the product data sheet will void the product
warrantee.
Device performance and specifications are only valid if an approved cell is used.
The original supplier takes no responsibility for any loss or damage resulting from the use of
an unapproved electrical cell.