User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved 6
Description
VP Series 2000 sensors measures temperature, acceleration, and velocity. Ranger Pro sensors detect
acceleration using piezoelectric ceramic sensing elements in the sensor base. The sensors derive velocity
from the acceleration signal. The Ranger Pro sensors also measure surface contact temperature using a
sensor in the device base. The sensor reports a single temperature per device. You can choose what
units are used to measure the data.
Temperature
A sensor embedded in the device base measures contact temperature.
Acceleration Overall
Discrete, piezoelectric sensing elements measure acceleration in the Z-axis
for single axis VP Series 2000 wireless sensors and in the X, Y and Z
directions for tri-axial VP Series 2000 wireless sensors. Overall acceleration
is calculated over 2.5 seconds.
Velocity Overall
Calculated from the acceleration waveform and the overall value is
calculated over a 2.5 second duration.
There are various versions of the device:
VP2000-01 ISA100.11a
Sensor
Detects velocity and acceleration in three axes (X, Y, and Z) and measures
surface temperature.
VP2000-02-01
WirelessHART
Tri-Axial Sensor
Detects velocity and acceleration in three axes (X, Y, and Z) and measures
surface temperature.
VP2030 ISA100.11a
Tri-Axial Sensor
Detects velocity and acceleration in three axes (X, Y, and Z) and measures
surface temperature.
VP2010 ISA100.11a
Single Axis Sensor
Detects velocity and acceleration in one axis (vertical, or Z) only and
measures surface temperature.
NR1210 ISA100.11a
Repeater
Enables you to extend the range between sensors and ISA100 backbone
routers.
For ISA100 networks, both the tri-axial and single axis sensors can also act as routers, although using the
router mode depletes the device battery more quickly.
If a VP Series 2000 ISA100 device cannot communicate with a backbone router, you can use the
VP Series 2000 ISA100 repeater (NR1210) or a VP Series 2000 ISA 100 device with routing enabled to
extend your ISA100 network. Although a VP Series 2000 ISA100 device can route up to 8 devices, we
recommend no more than three.