User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved 5
Hardware
Intended Use
VP Series 2000 devices are intended for monitoring purposes only and should not be used in control or
safety systems.
Compliance Information
This device complies with part 15 of the FCC Rules and contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's
license-exempt RSS(s). Operation is subject to the following conditions: l
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not approved by the responsible party could void the user's authority to
operate the equipment.
For complete compliance and hazardous location approval information, see the VP Series2000
Datasheet (20DD1974) and VP Series Warnings, Special Conditions and Additional Information
(DSDVP001) available from Divigraph.
Informations de conformité
Cet appareil est conforme aux dispositions de la section 15 des règles de la FCC et contient des
émetteurs / récepteurs exempts de licence conformes aux CNR d’Innovation, Sciences et
Développement économique du Canada (ISDE Canada) applicables aux appareils radio exempts de
licence.
• Cet appareil ne doit pas produire de brouillage, et
• Cet appareil doit tolérer tout type de brouillage subi, y compris ceux susceptibles de perturber le
fonctionnement normal de l’appareil.
Les changements ou modifications non expressément approuvés par la partie responsable de la
conformité pourrait annuler le droit accordé à l'utilisateur d’exploiter cet équipement.
Pour obtenir des informations complementaires à propos de la conformité et de l'approbation de cet
appareil en zone dangereuse, veuillez consultez VP Series2000 Datasheet (20DD1974) et VP Series
Warnings, Special Conditions and Additional Information (DSDVP001) disponibles auprès du Divigraph.