User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved ii
Copyright 2020 Divigraph (Pty) Ltd
All Rights Reserved
The information contained in this document is the property of Divigraph and its affiliates; and is subject
to change without prior notice. It is being supplied as a service to our customers and may not be altered
or its content repackaged without the express written consent of Divigraph.
Contact Information
When it is not possible to contact your local representative, use the following contact information:
Address
28 Prosperity Park, Computer Road,
Milnerton, Cape Town, 7441, RSA
Telephone
+27 (21) 065-0344
Email
support@divigraph.com
Internet
www.divigraph.com