User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved 15
8. To avoid damaging the e-module, you must first align the contact pins of
the e-module with the contact points in the case. Angle the e-module
and align the contact pins and back keyway.
9. Now rotate the e-module downward to align the notch on the other side
of the e-module with the notch in the case and press firmly. You can feel
or hear a click when it is in place. If necessary, hold the e-module in
place with your finger.
10. Inspect the exterior threads of the sensor case as well as the interior threads of the e-module
retaining ring to be sure they are not damaged.
11. Align the e-module retaining ring over the e-module. If needed, hold the
e-module in place with your finger.
12. To maintain the device’s IP rating, be careful to avoid damaging the O-rings. Turn the e-module
retaining ring clockwise until it seats against the O-ring before, fastening it with a reciprocating
motion (¼ turn back every turn) until the ring is hand-tight.
13. Verify that the device is properly sealed - there should not be any gap
between the e-module retaining ring and the case.