User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved 13
Installation and Configuration
Install Battery
We recommend that you install batteries in Ranger Pro devices in an indoors equipment room or a
similar environment. Do not replace batteries in a hazardous area.
! WARNING
HAZARDOUS ENVIRONMENT
RISK OF EXPLOSIVE ATMOSPHERE.
Do not install batteries in a hazardous area. Use only approved battery types
described in the VP Series Warnings, Special Conditions and Additional
Information (DSDVP001) available from Divigraph.
! NOTE
To maintain the device’s IP67 dust and water-resistant rating, assemble the device carefully.
To install a battery in a VP Series 2000 device:
1. Turn the e-module retaining ring counter-clockwise and stop when
resistance decreases. Place the device on a flat surface. Use your index
finger and apply firm pressure to the top of the e-module. Use your other
hand and continue to unscrew and remove the retaining ring.
2. Hold the device and e-module as shown. Use your thumb to press
against the e-module just above the metallic tab on the case. Apply a
slight radial force and push upward until the e-module is separated from
the case.