User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved 8
Network Requirements
Ranger Pro devices operate on compatible WirelessHART and ISA100.11a wireless networks and
gateways. Additional licenses may be required to activate these gateways.
ISA100 Network Requirements
Manufacturer
Gateway
Router
Divigraph
NG1120 Gateway
N/A
Yokogawa
YFGW410 (R2.01.04 or
equivalent)
YFGW410 (R2.01.04 or
equivalent)
Honeywell‡
WDM (R310.2-4 or later)
FDAP (OW 230 or later)
CISCO 1552S
‡ Honeywell OneWireless Wireless Device Manager using firmware R310.2-4 limits the maximum
number of VP Series 2000 wireless devices to 140 per gateway. To increase the limit to 160 or more
devices, upgrade to a newer version of the firmware when available.
WirelessHART Network Requirements
Manufacturer
Gateway
Access Point
Emerson‡
Wireless 1410/1420 Gateway
N/A
‡ Emerson gateway with firmware 4.7.84 or later is required.