Hurricane Ratings

THIRD ANGLE
PROJECTION
QSWB Wall Mounting Brackets Installation Instructions - Professional Installation Required 1. Ensure that the supporting wall structure that the bracket will be mounted on is capable of supporting the weight of the air conditioner unit and bracket and can support the anchor loads as indicated on the QSWB specification sheet, Pgs. 1 & 3. 2. Use the correct size wall mounting bracket (QSWB2000 or QSWB4000) to match up with the condenser unit weight. See Pg-1. 3. Remove the three wall mounting bracket parts and bag of hardware from the box. 4. Mount the horizontal glide track to the wall using 3 of the 5 anchors. Lag screws for wood and expansion anchors for concrete. Alternate anchors can be used by following the anchor schedule found in the QSWB specification sheet, Pg-4. 5. Mount the L-brackets to the guide track by using the hardware provided. (NOTE: Insert the 1 ¾ x 3/8 bolts and washers thru the L-bracket into the spring nuts). 6. Insert ¼-20 carriage bolts with nuts through the bottom side of the L-bracket for equipment mounting. Place rubber washer (vibration and noise reducers) and nut to the top of the L-bracket equipment mounting bar.
DO NOT SCALE DRAWING
REV.
A
DESCRIPTION
SHEET
5
OF 5
DWG. NO. MATERIAL:
THE INFORMATION SET FORTH IN THIS DOCUMENT AND RELATED INFORMATION IS THE CONFIDENTIAL PROPERTY OF DIVERSITECH
CORPORATION, AND IS NOT TO BE COPIED OR
REPRODUCED OR DISTRIBUTED IN ANY FORM WITHOUT PRIOR
WRITTEN PERMISSION FROM DIVERSITECH CORPORATION.
CONFIDENTIAL - PROPRIETARY - DO NOT COPY
DIMENSIONS ARE IN INCHES [MILLIMETERS] TOLERANCES ARE: ANGLES
±1.0°
FRACTIONAL SIZES X/Y ±1/64 INCHES
[MILLIMETERS]
.X = ±0.1
[ X
= ± 2.5 ]
.XX = ±0.01
[ .X = ± 1.3 ]
.XXX = ±0.005
[ .XX = ±0.13 ]
UNLESS OTHERWISE SPECIFIED:
A A
B B
4 4
3 3
2 2
1 1
28AUG17
Models: QSWB2000, QSWB2000SS, QSWB4000 & QSWB4000SS
A/C Condensing Unit
Wall Bracket Systems
AISI 1045 Steel / Sy >= 59ksi