Instructions / Assembly
General
The low prole vent termination kit allows both the intake
for combustion air and the exhaust vent to pass through a
standard sidewall. Follow these instructions as well as the
furnace installation instructions for installation of the intake/
vent pipe(s) and all furnace installation procedures. These
instructions are intended as an aid to qualied service
personnel for proper installation, adjustment and operation
of this unit. Refer to the furnace installation instructions for
intake/vent pipe sizing information.
This kit contains the following parts:
(1) Vent Cap
(1) Vent Plate
(1) Mounting Hardware
Key Installation Requirements
1. Examine all components for possible shipping damage
prior to installation.
2. Proper joint construction is essential for a safe installation.
Follow these instructions exactly as written. Check for
proper joint construction when joining pipe to ttings.
3. This venting system must be free to expand and contract.
Check for unrestricted vent movement through walls,
ceilings, and roof penetrations.
4. This venting system must be supported in accordance
with these instructions.
Warnings
o Do not operate the furnace without the side wall cap in
place as recirculation of combustion products may occur.
o If the venting system is not installed properly, recirculation
of ue gasses may occur, causing the intake pipe to
freeze shut during cold weather operation.
o Water may collect inside the combustion air pipe and ow
to the burner enclosure. Means shall be provided for
2