Safety Data Guide

SAFETY DATA SHEET
DiversiTech Corporation Chemical Emergency: P 800-255-3924
6650 Sugarloaf Parkway P 678.542.3600
Duluth, GA 30097 Page 2 of 4 F 678.542.3700
SECTION 3. HAZARDOUS INGREDIENTS INFORMATION
INGREDIENT CAS % or Range ACGIH TLV TWA OSHA PEL TWA:
Fiberglass N/A 20 – 25% N/A N/A
Mineral Fillers N/A 45 – 50% N/A N/A
Polyester Resin N/A 18 – 23% N/A N/A
Styrene Monomer 100425 0.6% by weight N/A 100 ppm
SECTION 4. FIRST AID MEASURES
General Advice: Avoid contact with skin and eyes.
Skin: Wash off immediately with soap and plenty of water.
Eye Contact: Flush with plenty of water. Consult a physician. Show this Safety Data Sheet to the doctor in attendance.
Inhalation: Remove to fresh air.
SECTION 5. FIREFIGHTING MEASURES
Flammable Limits in Air,
(% by volume): LEL 6.6% UEL 0.9% (Styrene)
Flash Point: 840°F
Autoignition Temp: N/A
Extinguishing Media: H
2
0, CO
2
, or dry chemical.
Fire Fighting Instructions: Recommended protective clothing, full face self contained MSHA/NIOSH approved breathing apparatus.
Unusual Fire and Explosive
Hazards: None
SECTION 6. ACCIDENTAL RELEASE MEASURES
Personal Precautions: Avoid contact with skin and eyes
Environmental Precautions: Do not let product enter drains
Methods For Cleaning Up: Flexi-Patch is a exible solid and cannot leak or spill. In case of accidental release, source of ignition should be removed
and the product placed in containers such as covered steel drums to await disposal. Wear appropriate personal protective equipment.
SECTION 7. HANDLING AND STORAGE
Handling: Use only in well ventilated areas. Keep away from heat and sources of ignition. Follow general industrial hygiene practice.
Storage: For maximum storage life and to maintain material workability, store below 72°F (22°C). Material is packaged in special bags impermeable to
styrene. Do not puncture bag. Reseal after partial use.
SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering Controls:
Engineering controls are not necessary if good hygiene practices are followed. Before eating, drinking or smoking wash face and hands thoroughly with
soap and water. Avoid unnecessary skin contact. Impervious gloves and apron are recommended to prevent skin contact. For operations where eye
or face contact can occur, wear eye protection such as chemical or splash proof goggles or face shield. Where exposures are below the permissible
exposure limit (PEL), no respiratory protection is required. Where exposures exceed the PEL, use respirator approved by NIOSH for the material and
level of exposure. See “ Guide to Industrial Respiratory Protection “ (NIOSH). Cutting, grinding or sanding of parts fabricated after curing of this material
may create respirable dust particles. Respiratory protection appropriate for this dust may be required. Refer to the regulated component section for
potential hazardous components in dust. Gloves, long sleeved shirt and safety glasses are recommended to prevent contact with any dust particles
generated.
Flexi-Patch
™