User Guide

Pressure Regulation

1. Connect the DrainDawg regulator to the outlet of the nitrogen or CO

cylinder. This connection should be wrench tight.

2. Connect the DrainDawg blue hose to the outlet ¾ SAE tting on the

DrainDawg pressure regulator. This connection should be hand tight.

3. Prior to opening the parent tank valve, make sure the pressure regulator

handle is backed out by turning it counterclockwise.

4. Open the parent tank valve. Do not exceed 3000psi inlet pressure as

this is the maximum rating of the regulator. Ensure there are no leaks.

Attach desired accessory to the other end of the blue house. Ensure this

connection is hand tight.

5. Set the pressure of the DrainDawg by regulating the pressure to the

desired setting by turning the pressure regulator handle clockwise. Do

not exceed the pressure rating for the desired accessory being used.

Warnings

• Caution: cylinders are highly pressurized. Always handle with care. Never

allow cylinders to be dropped, knocked over or subjected to excessive

heat.

• Never stand in front of or behind a regulator or tank when opening the

cylinder valve. Always stand so that the cylinder is between you and the

regulator.

• Do not use the regulator if there are any damaged parts on the regulator,

cylinder, or valve.

CK-141

The CK-141 can be used with other pipe sizes that may not work

with the DF-75. To use this accessory, connect the stationary tting

end of the CW-15 red hose to the end of the blow gun and the

rotatable tting end of the CW-15 red hose to the CK-141. Do not

exceed 100psi. C0

or Nitrogen may be used.

CW-15

CK-141

BLOW GUN

HOSE FROM

DRAINDAWG

SWIVEL END

NON-SWIVEL END

Included Accessories