Owner`s manual

2
O ptima FX Owner’s Manual
Ch. 3 Pg. 5
Copyright, Dive Rite All Rights Reserved January 2009
<WARN>0.8 0.7
1.1* 0.86 0.81
25.6 68F > 28.6
1.00 1.00 1.00
24.0 T :22:40
1.00 1.00 1.00
Stk Left -13 Min
1.00 1.00 1.00
Stk Left 129 Min
1.00 1.00 1.00
<OK> 1.0 1.0
21% NO STOP
Depth/Timer Mode
2
This mode cycles between THREE different screens. The PO for all cells is displayed
on the second line of all screens. The first screen is identical to classic mode and is the main
status screen. The second screen displays current depth, Temperature and maximum depth. The
third screen displays the current depth and the total dive time in the format
hours:minutes:seconds.
Depth/Timer/Stack Mode
2
This mode cycles between FOUR different screens. The PO for all cells is displayed on
the second line of all screens. The first three screens are the same as in Depth/Timer mode. The
fourth and final screen displays the remaining stack time. The stack time display is simply a
countdown timer based on a user programmed limit. This timer counts once the diver
submerges. An alarm will be generated once this time is exceeded and the remaining stack time
will now show a negative time.
Display of Deco Information
When the secondary deco is enabled and the deco display is
2
enabled, the PO information on the second line on the display will
replaced with decompression information. Depth/Timer mode displays
the deco information after the depth and time screens and in Depth/Timer/Stack mode; the
information is displayed after the depth and time but before the stack time data.
The first “deco” screen depends on the status of the diver’s decompression obligation.
The top line is the standard status screen with the change being on the second line. Instead of the
2
PO being displayed, the oxygen percentage of the selected diluent and “No Stop” is displayed
until the diver enters a required decompression stop. This screen is displayed for approximately
2 seconds.