Quick Start Guide www.DiveRite.
Congratulations on your Dive Rite NiTek Q purchase. This Quick Start Guide is intended to familiarize you with the basic functions of this computer. It is not a substitute for the user manual found in our library at www.DiveRite.com. You MUST read the NiTek Q user manual in its entirety before diving this product. The NiTek Q is an electronic device and electronic devices can fail. NEVER dive this computer without a back up device or dive tables.
Menus: SET Mode continued the B button to choose your GF: CONS 2 = 30/75 (default) CONS 1= 40/100 CONS 0= 75/95 the A button to set your P02 alarm. The computer will automatically advance to your %02 gas option. NOTE: Up to 2 different gas mixes can be programmed, but if you are only using 1 mix, you only need to set MIX 1. the A button to select your GF. The computer will then scroll to the flashing Imperial/Metric option. Additional Settings Imperial/Metric the B button to select your %02.
PROFILE is where graphic profiles of each dive are stored. the B button to activate the screen. Continue pressing the B button to scroll through your logged profiles. Second Underwater Screen PC - Workbench dive software allows the Q diver to perform dive planning or gas mixes on either a PC or . MAC. An optional upgrade to the Workbench Logbook allows you to upload dive data and view dive profiles. Contact Dive Rite at Qunlocks@diverite.com for information about the Workbench upgrade.
Using Your NiTek Q The following is a checklist of general things you should pay attention to before, during, and after a dive. Before A Dive: Be sure the computer is charged. The Q can be charged from any USB connection or from its included charger. Ensure that the USB cap is secure. Check that the proper time and date are set. Check that the proper mixes and modes are set. Review the dive plan for maximum depth, times, and for mixes you plan to use.
