Installation manual

30
The pipe protection grills must be applied outside the wall where the unit is installed.
Cut part of the right grill (looking at the unit from the rear) in order to permit the con-
densate drainage pipe to exit correctly (see Figure).
10. Rear grills
At the end of installation operations, the grills must be applied to the air circulation pipes.
As above, this particular measure will ensure better unit operation because not only will the air be filtered and therefore the heat
exchange system will remain cleaner (and maintain yield over a longer period of time), but will also prevent the deposit of leaves or
other clogging material in the pipes and infiltration by birds or other small animals.
These grills can be quickly removed and cleaned whenever necessary.
AIR SUCTION
VIEW OF AIR CONDITIONER REAR GRILLS
AIR EXPULSION
CONDENSATE
DRAIN
11. Connect the air conditioner to the power supply by plugging in the plug. Before starting, make sure that the plug is adequate to
the air conditioner's power absorption and the regulations in force.
LEFT
RIGHT