Technical data

FSG 2T PS

Portable VHF/AM Airband Transceiver

DITTEL  D10077 May 2010

4.10 Lighting the Frequency Display and Front Panel

Lighting of the frequency display

and front panel is activated

by pressing the red test button of the battery indicator

4.11 Turning OFF the radio

Always turn OFF the radio after use by rotating the VOL switch

to the fully ccw position to prevent unnecessary discharge of the

battery. During standby or carrying, the handheld microphone

(A/N F10346) can be hung onto the right flange of the case.

4.12 External Power Supply

The capacity of the built-in battery may not be adequate due to

frequent transmitting operations or very long operating times without

possibility to recharge. Radio operation can be enabled through an

external 12 Vdc power source such as an automobile battery via our

Car Cable F10393 which fits into the cigarette lighter socket of most

cars (minus on common ground).

4.13 Removing & Installing the Transceiver

IMPORTANT!

Switch OFF the radio first! This is a simple precaution which

helps protect the solid state circuitry and extends the

operating life of your avionics equipment.

To dismount the transceiver FSG 2T from the Carrying Case PS,

remove the two cross-recessed screws

and lift off the

matching plate. Carefully pull out the transceiver together with the

adapter plate, wire harness and antenna cable. Open sliding lock

of 15-pole receptacle, unplug wire harness and antenna plug.

To install the transceiver, carefully pull out the wire harness of the

case, connect the 15-pole receptacle and secure it by the sliding

lock. Plug antenna cable and secure it by twisting the BNC plug.

Slowly insert transceiver into the case. Put on the matching plate

and fix it by the two cross-recessed screws

. Check fixing and

function.