Technical data

FSG 2T PS
Portable VHF/AM Airband Transceiver
32 DITTEL  D10077 May 2010
4.9 Memory Programming
IMPORTANT!
Memory programming is disabled for all FSG 2T radios which
are marked CH ONLY!
Memory programming is disabled at a supply voltage below
11 Vdc.
When storing a frequency into a memory the "old" frequency
will be overwritten without warning!
Up to 20 non-volatile memories can be user-programmed. They are
accessible after calling up the respective CHANNEL MODE.
4.9.1 Programming while in the DIRECT TUNE MODE:
Example:
Turn the F/CH knob
6
to change the underscored portion of the
frequency to the desired frequency.
Press the same knob once and note that the cursor has jumped to
underscore the other portion of the frequency.
Turn the F/CH knob
6
to select the desired frequency.
Press the STO button
3
to initialize storing.
Release the STO button. The "dc" display disappears, a flashing
"CH" together with the underscored last used channel number is
shown. The active frequency is now ready within 1 minute to be
stored in any of the 20 memory channels.
Use the F/CH knob
6
to select the desired memory location.
Press and hold the STO button 3 for at least 1 second. The
flashing "CH" should change to steady "St" and the underscore
disappears indicating that it has been stored into memory
successfully.
Release the STO button and the radio returns to DIRECT TUNE
MODE. The stored frequency is now the active frequency.