Technical data

FSG 2T PS
Portable VHF/AM Airband Transceiver
May 2010 DITTEL  D10077 17
6
F/CH Knob Rotary control and push button = dual function
Pressing the F/CH knob once
while in the DIRECT TUNE MODE changes the access from kHz to
MHz or vice versa from MHz to kHz. The active access to MHz or
kHz is underscored by a cursor.
While in the CHANNEL MODE or CH ONLY pressing the F/CH knob is
without function.
Rotating the F/CH knob
while in the DIRECT TUNE MODE will increment or decrement the
MHz or kHz portion of the active frequency with rollover at each
band edge.
while in the CHANNEL MODE changes the channel memory number
and associated frequency. All channel numbers (1 to 20) can be
used.
If the FSG 2T is set to CH ONLY Mode rotating the F/CH knob changes
the channel memory number and associated frequency. All 20
channel numbers are adjustable.
IMPORTANT!
Only ONE control element may be operated at a time. If more
than one element is operated simultaneously, function change
is blocked.
7
Frequency Display
DIRECT TUNE
MODE
CHANNEL MODE
or CH ONLY
Frequency Display, the 5-digit Liquid Crystal Display (LCD) can be
back-lit.
Frequency display complies with ICAO rules.
Initial boot at Switch-ON / Power ON
Displays all segments for 2 seconds
Clear Display for 0.5 seconds
Shows Firmware Version for 0.5 seconds
Goes to last user setting (operating mode and frequency, refer to
paragraph 3.3).
8
Fixing Screws
Two cross recessed screws, M 4 8, to fix the transceiver in the
case.
9
Loudspeaker 8 Ohm, 3 Watt, tropics-proof.
To make received signals audible; volume adjustable with VOL control
1
. It is not switched OFF when using a headset connected to
13
.