Technical data

FSG 2T PS
Portable VHF/AM Airband Transceiver
16 DITTEL  D10077 May 2010
consumption.
Rotating the SQ knob clockwise (cw) achieves Receiver muting.
To eliminate ignition noise or RF interference adjust the SQ knob
up to the full clockwise (cw) position. This gradually increases the
required RF signal to exceed the SQ threshold (max. threshold
5 µV / -93 dBm).
3
STO (STORE) Push button
When pressing the STO button (within approx. one minute)
storing of a frequency in one of the memory channels is initiated,
or
storing of a frequency is confirmed (at least 1 sec).
20 frequencies may be programmed in non-volatile memory
channels. The channel memory numbers (1 20) are user
programmable.
If the FSG 2T is set to CH ONLY Mode this STO button is without
function!
4
TX/RX LED The TX/RX 3-color Status LED on the front panel indicates the
following:
CLEAR...................indicates a Standby condition or radio is OFF.
STEADY RED ..........indicates a Transmit condition without or too low
modulation.
FLICKERING
YELLOW.................indicates a Transmit condition with proper
microphone signal / modulation.
STEADY
YELLOW.................indicates a Transmit condition with too much
modulation or background noise (microphone
sensitivity too high)
STEADY GREEN......indicates a Receive condition; Squelch is open
automatically (or set OFF manually).
5
F/CH Button Push button
When pressing the F/CH button
while in DIRECT TUNE MODE (MHz or kHz is underscored), this will
change the radio into CHANNEL MODE, or
while in CHANNEL MODE (Channel number is underscored), this will
change the radio into DIRECT TUNE MODE.
The last used frequency in each mode remains. This allows toggling
between two operational frequencies by just pressing the F/CH button.
If the FSG 2T is set to CH ONLY Mode pressing the F/CH button will
show the DC supply voltage for 5 seconds (instead of continuous
channel number).