Technical data

FSG 2T PS
Portable VHF/AM Airband Transceiver
12 DITTEL  D10077 May 2010
microphones and external power supply, and a built-in loudspeaker.
The lock-in type carrying handle completes our robust FSG 2T PS unit.
2.3 Equipment required but not supplied
Vertically polarized VHF airband antenna, frequency range
minimum 118 to 137 MHz, 50 Ohm, e.g., DITTEL spring steel band
antenna, A/N F10345.
Dynamic Microphone 30 to 600 Ohm, e.g., WD handheld dynamic
microphone with PTT-key, 5-pole DIN plug and coiled cord, A/N
F10346.
Automatic Battery Charger, e.g. DITTEL DL-50A, 115 Vac /
230 Vac, output 13.8 Vdc / 600 mA, A/N F10385.
When operating the unit on a 24 Vdc source a suitable 14
Vdc/12 Vdc Converter of at least 3 Amps must be used!
2.4 System and Type Approval Information
The VHF/AM Airband Transceiver FSG 2T complies with ICAO 25 kHz
channel spacing and also meets applicable National and International
Type Approval requirements, for any airborne and ground operation:
JTSO Authorization LBA.O.10.911/103 JTSO (LBA Luftfahrt-
Bundesamt), replaced by ETSO Authorization EASA.21O.1304
(2009), is based on EUROCAE ED-23B Airborne requirement (25
kHz ONLY CH spacing).
FM Immunity requirements according to ICAO ANNEX 10 against
FM Broadcast RF Interference.
Audio filtering required in areas with CLIMAX operation in 25 kHz
channel spacing.
Associated EUROCAE ED-14D / RTCA DO-160D Environmental
requirements for Fixed Wing and Helicopter aircraft.
Associated EUROCAE ED-12B Software requirements based on
ED-12B, Level C.
Type Approval requirements for ground operation, meeting ETSI
EN 300 676.
CE Conformity requirements for ground operation, meeting ETSI
EN 301 489-1 and -22.
DFS (Deutsche Flugsicherung) No. D - 0002/2002 German
(ground) Type Approval.
DIN / ISO 7637-1 Dc supply in 12 Vdc vehicle,
KBA No.: e1 03 2777.
FCC Compliance with Part 15 (receiver) and Part 87 (transmitter),
FCC ID: BVYFSG2T.
FAA / TSO Authorization