Technical data

VHF/AM RADIO FSG 2T
6 Operation
June 2014 FAV_D10048 61
6.5 Memory Programming
IMPORTANT!
 Memory programming is disabled at a supply voltage below 11 Vdc.
 When storing a frequency into a memory the "old" frequency will be
overwritten without warning!
Up to 20 non-volatile memories can be user-programmed. They are accessible after
calling up the respective CHANNEL MODE.
6.5.1 Programming while in DIRECT TUNE MODE:
Example:
Turn the F/CH knob to change the underscored portion of the
frequency to the desired frequency.
Press the same knob once and note that the cursor has jumped
to underscore the other portion of the frequency. Turn the F/CH
knob to select the desired frequency.
Press the STO button to initialize storing.
Release the STO button. The "dc" display disappears, a flashing
"CH" together with the underscored last used channel number is
shown. The active frequency is now ready within 1 minute to be
stored in any of the 20 memory channels. Use the F/CH knob to
select the desired memory location.
Press and hold the STO button for at least 1 second. The
flashing "CH" should change to steady "St" and the underscore
disappears indicating that it has been stored into memory
successfully.
Release the STO button and the radio returns to DIRECT TUNE
MODE. The stored frequency is now the active frequency.