Technical data
VHF/AM RADIO FSG 2T
3 Installation
June 2014 FAV_D10048 19
3 Installation
3.1 General
This section contains instructions and suggestions to be considered before installing the
radio FSG 2T into an aircraft. Close adherence to these suggestions will assure more
satisfactory performance from the equipment.
Information in this section is intended for certified avionics shops only. Work such as
installation, wiring and testing should only be carried out by a qualified technician!
IMPORTANT!
If installation into an aircraft is made by other than a certified avionics shop,
you have to consult your responsible aircraft Avionics Airworthiness
Inspector - before the installation – to get authorized certification of your
completed installation.
The conditions and tests required for ETSO and FAA-TSO approval of this
article are minimum performance standards. It is the responsibility of those
desiring to install this article either on or within a specific type or class of
aircraft to determine, that the aircraft installation conditions are within the
ETSO or FAA-TSO standards. If not within these standards, the article
FSG 2T may be installed only if further evaluation by the applicant
documents an acceptable installation and is approved by the Administrator.
3.2 Unpacking and Inspecting Equipment
Unpack the equipment carefully and inspect each item for evidence of damage incurred
during shipment. FSG 2T serial number must comply with relevant details mentioned in
Airworthiness Approval Tag and delivery note details attached to the shipment.
If a damage claim must be filed, save the shipping container and all packing materials to
substantiate your claim. The claim should be filed with the transportation company as
soon as possible.
If a damage is noted after the first test, notify the transportation company in writing with
advance e-mail, phone or fax advice about hidden transport damage.
A copy of such a claim including all information from the type label is to be forwarded
without delay also to f.u.n.k.e. AVIONICS GmbH.
3.3 Pre-installation Test
Before installing the radio into an aircraft, vehicle or portable carrying case, a short but
comprehensive functional bench test through a certified avionics shop is recommended.
a) Interconnect the radio with a test wiring harness (according to Figure 3 - 1) to the test
bench setup. For FSG 2T set supply to 13.8 Vdc on radio input terminals. Turn ON the
radio with the VOL switch on front panel. Switch OFF the Squelch by rotating the SQ
knob to fully counter-clockwise position.
Verify, whether on all channels within 118 ... 136.975 MHz almost identical, strong,