Data Sheet

DITEK's POC (Power Over Coax) series surge protectors utilize
state-of-the-art hybrid circuit technology to protect Ethernet and PoE
Extenders from damaging transients; typically induced onto long
video feeds that run between head-end equipment and externally
mounted cameras. Whether the need is for video protection on
cameras, switches or DVR's, the POC provides optimum protection
without signal loss.
The DTK-POC is a single channel device, used to protect externally
mounted cameras. For complete protection install the POC at each
externally mounted camera, and the 16-Channel RM16POC at the
head-end equipment
Ethernet and POE Extenders Over Coax - Surge Protector
General Product Specifications
DTK-POC
DTK-POC
One DITEK Center
1720 Starkey Road
Largo, FL 33771
Document: SPS-100079-001 Rev 3 09/14
©2014 DITEK Corp.
Specification Subject to Change
1-800-753-2345 Direct: 1-727-812-5000
Technical Support: 1-888-472-6100
www.ditekcorp.com
DTK-POC Camera, Base Module
Service Voltage 60VDC
Voltage Clamping
1000VDC 1mA
61.6V C-S
150V C-G
62.4V S-G
Peak Surge Current
10/1000uS
100 A
DTK-POC
Specifications
Agency Approvals: UL497B
Connection Method: BNC Female In/Out
Data Rate: 10/100 BASE-T Ethernet
Max Continuous Current: 0.2 Amps
Impedance: 75 Ohms
Insertion Loss: -0.048dB (10MHz), -0.035dB (100MHz)
Protection Modes: CP-S, CP-G, S-G
Center Pin - Shield, Center Pin - Ground, Shield - Ground
Operating Temperature: -40°F - 158°F (-40°C - 70°C)
Maximum Humidity: 95% non-condensing
Dimensions: 1.0”H x 3.2”W x 2.2”D
(25.4mm x 81.3mm x 55.6mm)
Weight: 2.5oz (71g)
Housing: ABS
Product Features
• Protects power, video and data on IP cameras
• BNC Female In/Out connection with external
grounding screw
• Ethernet data speed without signal degradation
• Multi-stage, SAD technology, hybrid design
• PoE Plus ready for high-wattage applications
• Small footprint easy installation
• Ten Year Limited Warranty