Operation Manual
- 41 -
0DT829 15/10/2012
Installer:
DETACH AND DELIVER TO THE CUSTOMER
USE INSTRUCTIONS
GENERAL SAFETY PRECAUTIONS
This user handbook is an integral and essential part of the product and must be delivered to the users. Keep
this document and pass it on to any future users.
This automation is a; it must be used for the specic purpose for which it was designed.
Any other use is to be considered inappropriate and so dangerous. Ditec Entrematic declines all responsibility
for damage caused by improper, incorrect or unreasonable use.
USE PRECAUTIONS
• Do not enter the door action area while the door is moving.
• In the event of a fault or malfunctioning, turn off the main switch. The operations of maintenance, adjustment
and repair must be carried out by skilled and authorised staff.
• Each automation has its own “Installation and Maintenance handbook”, reporting the periodical maintenance
plan. Please take care to check all the safety devices.
BUTTONS
• Full opening: the door opens completely. The stroke can be xed via the end stop microswitch.
• Partial opening: the door opens partially, to a point time-regulated by the RP trimmer.
• STOP: the door stops immediately.
• Closing: the door closes completely. The stroke can be xed via the end stop microswitch.
MANUAL RELEASE LEVER (for emergency reopening).
Warning: before using the manual lever, turn the equipment off, putting the main switch on “0”.
• When the lever is released, the brake is regularly working.
• Pulling the lever, the brake is unclamped.
To raise manually the panel, in case of power lacking or damage, act as follows:
• pull the release lever (g. 2), releasing the brake;
• raise the panel on open door position;
• leave the lever back (g. 3), in order to run the brake again.
Stop the opening of the panel before the safety edge hits the crosspiece.
Ditec S.p.A.
Via Mons. Ban, 3
21042 Caronno P.lla (VA) - Italy
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditecentrematic.com
EN