Technical data

26
IP1839EN • 2012-07-31
DETACH AND DELIVER TO THE CUSTOMER
Installer:
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. [phone] - Fax [phone]
www.ditec.it - [e-mail]
23.2 Manual release instructions
Carry out blocking and release with the motor switched off.
Do not enter within the operating range of the door.
If released, the door may move on its own.
NOTE: to remove power from the door, disconnect the power supply and batteries (if present).
In case of emergency, perform the following operations to open the door manually:
- Internalcordrelease(g.1):
pull the cord down until the lock release lever is actioned, then open the door manually while still pulling
down on the cord.
- ASB2externalcordrelease(g.2):
turn the release handle 90° in either a clockwise or anti-clockwise direction, then open the door manually.
- ASB1externalcordreleasewithkey(g.3):
- turn the key 90° in an anti-clockwise direction;
- extract lock block and pull the cable until the lock release lever is actioned;
- move the door slightly;
- insert the block in the lock and turn 90° in a clockwise direction;
- remove the key and open the door manually.
To restore motorized functioning, move the door manually; the release mechanism will reconnect automatically.
TM
Fig. 1 Fig. 2
Fig. 3
1 2 3