Technical data

IP1839EN • 2012-07-31

20. START-UP

WARNING The operations related to point 5 are performed without safeties.

The trimmer can only be adjusted with the automation idle.

The automation automatically slows when approaching the end stops.

At every start-up the control panel receives a RESET and the rst operation is performed

at reduced speed (automation position acquisition).

1- Make a jumper for the N.C. safety contacts.

2- Set TC=MAX and R1=MAX.

3- Use DIP2 to set the required direction.

4- Manually move the door and make sure the entire stroke is correct and without friction.

5- Switch on and check that the automation is operating correctly with subsequent opening and closing

commands.

6- Connect the safety devices (removing the relative jumpers) and check they work correctly.

7- If required, activate automatic closing and adjust the time with the TC trimmer.

8- Set the obstacle thrust with the R1 trimmer.

WARNING: check that the working forces exerted by the door wings are compliant with EN12453-EN12445

regulations.

9- Connect any other accessories and check they operate correctly.

NOTE: in the event of servicing or if the control panel is to be replaced, repeat the start-up procedure.