Installation manual

OPERATING INSTRUCTIONS FOR SWING GATES AUTOMATION CUBIC6
DITEC S.p.A.
Via Mons. Ban, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. [phone] - Fax [phone]
www.ditec.it - [e-mail]
Installer:
ON
OFF
RELEASE INSTRUCTIONS
In the event of failure or if there is no voltage:
CUBIC6SBL: insert the lock release lever and rotate by 180°
(g.1). Release any electric lock. Manually open the gate.
CUBIC6SBD: insert the lock release key in the lock and rotate
by 180° (g.2). Release any electric lock. Manually open the
gate.
BLOCKING INSTRUCTIONS
CUBIC6SBL-CUBIC6SBD: rotate the lock release lever or key
by 180°. Move the door wing manually until it is completely
reattached.
Attention: carry out the door wing blocking and release with the
motor switched off.
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential part
of the product and must be supplied to the user.
Read them carefully as they contain important indications for
the safe installation, use and maintenace.
These instruction must be kept and forwarded to all possible
future user of the system.
This product must be used only for that which it has been ex-
pressely designed.
Any other use is to be considered improper and therefore dangerous.
The manufacturer cannot be held responsible for possible da-
mage caused by improper, erroneous or unresonable use.
Avoid operating in the proximity of the hinges or moving mecha-
nical parts.
Do not enter the eld of action of the motorised door or gate
while in motion.
Do not obstruct the motion of the motorised door or gate as this
may cause a situation of danger.
Do not lean against or hang on to the barrier when it is moving.
Do not allow children to play or stay within the eld of action of
the motorised door or gate.
Keep remote control or any other control devices out of the reach
of children, in order to avoid possible involuntary activation of
the motorised door or gate.
In case of breack down or malfunctioning of the product, discon-
nect from mains, do not attempt to repair or intervene directly
and contact only qualied personnel.
Failure to comply with the above may create a situation of
danger.
All cleaning, maintenance or repair work must be carried out by
qualied personnel.
In order to guarantee that the system works efciently and
correctly it is indispensable to comply with the manufacturer’s
indications thus having the periodic maintenance of the motori-
sed door or gate carried out by qualied personnel.
In particular regular checks are recommended in order to verify
that the safety devices are operating correctly. All installation,
maintenance and repair work must be documented and made
available to the user.
TEAR OFF AND DELIVER TO USER
CUBIC6SBL
Fig. 1
CUBIC6SBD
Fig. 2