Installation manual

CUBIC6 - IP1812

3.5 Geared motor installation

After installing the foundation casing, the respective lever and

release mechanisms go before the installation of the gear motor

as shown in the gure.

Note: carefully clean the bottom of the foundation casing from

dirt or cement to guarantee an even laying of the gearmotor.

3.6 Installation with CUBIC6L-CUBIC6LG

Insert lever [A] on the gearmotor and position the mechanical

stop [B] and [C] and adjust it, as shown in the gure.

3.7 Installation with CUBIC6TC

Insert pinion [A] and join the two pinions by means of the chain

[B], as shown in the gure.

Lubricate the chain and the lever mechanism as indicated in

the gure.

3.8 Installation with CUBIC6TI-CUBIC6TIG

Fix the plate [A], then insert, x and lubricate the gears [B], [C]

and [D]. Position the sphere [E] as shown in the gure.

3.9 CUBIC6FM installation

It is possible to limit the travel of the wing by means of magnetic

limit switches.

Choose and install the magnetic limit switches as indicated in

the relative manual.

Make the electrical connections as shown in the control panel.

Attention: the magnetic limit switches cannot interrupt the power

supply to the motor.