Installation manual

11
CROSS5-7-8 - IP1747
GB
1. TECHNICAL DATA
Cross5E Cross7E Cross7EH Cross8E
Power supply 230 V~ / 50 Hz 230 V~ / 50 Hz 230 V~ / 50-60 Hz 230 V~ / 50 Hz
Absorption 1,5 A 2 A 1,5 A 3 A
Torque 500 N 700 N 600 N 800 N
Condenser 12,5 µF 16 µF - 22 µF
Max. run 20 m 20 m 20 m 20 m
Door speed 0,18 m/s 0,18 m/s 0,12 ÷ 0,20 m/s 0,18 m/s
Max. door weight 400 kg 600 kg 600 kg 800 kg
Service class 3 - FREQUENT 4 - HEAVY DUTY 4 - HEAVY DUTY 4 - HEAVY DUTY
Min. num. of consecutive cycles 20 30 50 30
Intermittence
S2 = 15 min
S3 = 25%
S2 = 20 min
S3 = 50%
S2 = 30 min
S3 = 50%
S2 = 20 min
S3 = 50%
Temperature -20 °C/+55 °C -20 °C/+55 °C -20 °C/+55 °C -20 °C/+55 °C
Degree of protection IP24D IP24D IP24D IP24D
Control panel E1 E1A 73RG E1A
2. REFERENCE TO ILLUSTRATIONS
The given operating and performance features can only be guar-
anteed with the use of DITEC accessories and safety devices.
2.1 Standard installation references (fig. 1)
[1] Radio
[2] Flashing light
[3] Key selector
[4] Geared motor + electrical board
[5] Photocells
[6] Rubber hip / Sensitive hip
[7] Opening and closing stop
[8] Connect power supply to an omni-pole switch with a contact
opening gap of no less that 3 mm (not supplied by us).
Connection to supply mains must be carried out in an
independent raceway separate from control connections
and safety device connections.
2.2 Geared motor references (fig. 3)
[9] Geared motor
[10] Carter
[11] Manual lock release
[12] Electrical board
[13] Limit-switch spring
[14] Pinion
[15] Internal photocell
[16] Courtesy light LUXK7 (optional)
[17]
BATK7 battery kit (optional, only for Cross7EH)
3. INSTALLATION
Unless otherwise specified, all measurements are expressed
in millimetres.
3.1 Preliminary checks
Check for gate stability (derailment and sideways falling),
that the slide wheels are in good condition and that the
top guides do not cause any friction.
The sliding track must be securely anchored to the ground and
fully exposed along its full length.
It must be perfectly smooth so as to avoid jamming of the
gate.
Provide opening and closing stops.
Note: make sure that the gate is securely inserted in the slideway
so that it cannot come out of the slideway and fall.
In case of slits being present on the gate, cover them to avoid
any risk of cutting.
To reduce impact force installation of safety devices at gate
ends is recommended.
3.2 Base plate prearrangement
- First, insert the screws into the base plate blocking them
with a low nut [P], then, fold the tang to avoid displace-
ment.
- Take out the preformed wall anchors with a downward
movement and with the help of a hammer to ensure proper
anchorage to the concrete.


Cross7E-7EH-8E
Cross5E