Instruction Manual
22
IP2042EN 2012-07-24
4.1 )asten detail [] to pro¿le 820 as shown in the dia-
gram.
Note: during the instaOOation of the ¿[ture, in order to oEtain the
SroSer hori]ontaO Sosition of the moEiOe Sanic wing, Ooosen the
fastening screws and adMust the screw shown in detaiO >@, as
shown in the diagram
4.1 If the width of the mobile wing is greater than 1000 mm insert
reinforcement 417 into pro¿le 820 as shown in the diagram.
4.17 Insert detail [] into pro¿le 820 as shown in the diagram.
Note: Be sure to take note of the wing¶s oSening direction
4.18 Position detail [] in correspondence to detail [4] and fa-
sten it as shown in the diagram.
Note: during the instaOOation of the ¿[ture, in order to oEtain the
SroSer Ereakawa\ strength for the moEiOe wing, use the OateraO
screws to adMust detaiO >@, as shown in the diagram
4.1 Insert detail [] into pro¿le 820 near detail [] as shown
in the diagram.
4.20 Insert the seal 87 onto the PAM4M pro¿le 808 or
else the PAM4/ pro¿le 821 as shown in the diagram.
$ttention: 2rient seaO as indicated in the ¿[tures manuaO
0ake a hoOe in the seaO that corresSonds with the thickness
adMustment of the Sush gOass >@ as shown in the Sicture
4.21 Insert detail [7] into pro¿le 820 as shown in the dia-
gram.
$ttention: 2rient detaiO >@ in the same manner as seaO