Instruction Manual

16
IP2042EN  2012-07-24
RXTX
OPENOPEN
CONTROL PANEL
COMH-K
Magnetic switch Magnetic switch
Brown
Blue
Brown
Blue
Black
Blue
Black
Brown
DO NOT
CONNECT
Blue
Black
Brown
0
1
9
STOP
9
TX
Grey
Black
LED
RX
25
15
23 23
15
25
13
103
25
- Perform the electrical connections as shown in the diagram.
$ttention: ,f the &20+. function seOector is used, connect
the receiYer¶s Erown caEOe to terminaO  on the seOector
- An\ other arrest devices must be connected in series to
terminal  (STOP).
- :hen the receiver (5;) and the transmitter (T;) of the
photocell SIC852 are powered and correctl\ aligned the
green /ED on the transmitter T; and the \ellow /ED on the
receiver 5; will light up. The \ellow /ED on the receiver will
go out when the\ are no longer correctl\ aligned.
- Once installation has been completed checN to maNe sure
that the force required to open each single wing does not
e[ceed 220 N.
This reading must be taNen at 1 m from Àoor level in corre-
spondence to the closure side of the wing (opposite to the
hinges). The breaNawa\ force can be adjusted as indicated
in paragraph 1.18 and 2.24.
- ChecN that the door¶s automatic movement stops when the
wings (mobile and ¿[ed) are released. The SIC852 pho-
tocell serves the purpose of detecting the release of the
mobile wings while the magnetic micro-switch serves the
purpose of detecting the release of the ¿[ed wings.
- If installed the photocells CE/P5 [27] that detect the pre-
sence of people and objects in the passage chamber must
be connected as shown in the manual of the electronic con-
trol panel of the automation s\stem.
3 AST ELECTRICAL CONNECTIONS