Instruction Manual
15
IP2042EN 2012-07-24
2.24 )asten detail [22] to pro¿le 80 situated above the wing
as shown in the diagram.
Note: 'uring the instaOOation of the ¿[ture, detaiO >@ must Ee
Sositioned in corresSondence to its internaO connection with de
taiO >@ and the Erush 63$= must Ee trimmed
,n addition, in order to oEtain the SroSer Ereakawa\ strength for
the ¿[ed wing, use the OateraO screws to adMust detaiO >@
2.2 During the installation of the ¿[ture detail [2] must be
positioned in correspondence to the magnetic limit switch [1].
Drill the appropriate holes in order to fasten detail [2] to pro¿le
80 situated above the wing as shown in the diagram.
2.2 :ith PAM4M pro¿les insert the glass [] into the ¿[ed
wing as shown in the diagram.
A
A
2.27 Set the glass spacers [A] shown in the diagram so that
the\ provide proper support.
2.28 :ith PAM4M pro¿les insert the seals into the glass-blo-
cNing pro¿les [8] as shown in the diagram.
2.2 :ith PAM4M pro¿les insert the glass-blocNing pro¿les
[8] onto the mobile wing until the\ clicN as shown in the dia-
gram.
2.0 During the installation of the ¿[ture position detail [24] in
correspondence to detail [11] on the ¿[ed wing and fasten it to
the Àoor so that it is aligned with the ¿[ture as shown in the
diagram.
2.1 During the installation of the ¿[ture fasten pro¿le 100
to the Àoor as shown in the PAM4/ AST or PAM4M AST
manual.
Note: 'o not Saint Sro¿Oe after it has Eeen fastened to
the Àoor