Instruction Manual
13
IP2042EN 2012-07-24
2.8 )eed the cable through the upper portion of the wing and
maNe it to come out in order to allow for the connection of the
magnetic limit switch as shown in the diagram.
2. MaNe the limit switch and photocells cables come out of the
hinge side vertical upright as shown in the diagram.
2.10 Attach pro¿le 81 and insert detail [1] as shown in the
diagram.
2.11 Insert and fasten detail [14] as shown in the diagram.
Note: 'uring the instaOOation of the ¿[ture, adMust detaiO >@ so
that detaiO >@ is SroSerO\ connected Eetween the ¿[ed wing ad
the Serimeter Sro¿Oe
2.12 Attach the magnetic limit switch [1] to its relative bracNet
as shown in the diagram.
2.1 Insert the brush SPAZ4811 into pro¿les 24 and 80 as
shown in the diagram and blocN it to prevent it from sliding.
2.14 )asten detail [1] to pro¿le 24 as shown in the dia-
gram.
2.1 )eed the cable through the upper portion of the wing and
maNe it to come out in correspondence to the photocell cable
as shown in the diagram.