User Manual

- 41 -
0DT829 01-12-2021
FUSES
ID Value Size Circuit
F1 - F2 12A - 500V 10.3 x 38 Single phase line
COMMAND NOTES
Opening position at 170 mm from the crosspiece
Partial opening position From 200 mm, from oor to
opening position
Closing position on floor
POSITION ADJUSTMENT
TROUBLESHOOTING
Display message Problem Check
Current limit exceeded Requested motor torque
exceeds available torque.
• Reduce opening speed.
• Check power supply.
• Check power supply wiring.
Encoder battery Absolute encoder battery at or
position read error
• Switch o󰀨 the control panel, wait 3 minutes and
reconnect the power supply.
If the problem is not resolved, try again.
• If the encoder battery message remains displayed,
replace the encoder.
Insert brake resistance Voltage on BUS exceeds
threshold
• Switch o󰀨 the control panel, wait 3 minutes and
reconnect the power supply.
• If the error reoccurs, check that the voltage on the
BUS is lower than 360 V.
Max. BUS voltage BUS voltage exceeds threshold • Switch o󰀨 the control panel, wait 3 minutes and
reconnect the power supply.
• Check the control panel power supply voltage.
52E
P5
P3 P4P1 P2
41 40 20 9 8 4 3 2 1 1 0 LAMP1 11 12 13
ON
OFF
1 2 3 4 5 6 7 8
DL
2
3
4 5
6 7
DL
M7
M4A
M5
M6
M3
BACK
M4
1 IN NC C NO
M2
J4
15
S3 S4
S5 S2
SAFETY OPEN
F2F1
230 V
50/60 Hz
GND
L N
+F -F U V W
ON
EN