User Manual

SK350 Operator’s Manual Controls - 21
CMW
5. Tachometer/Hourmeter Displays engine speed and
operating time.
Use hourmeter to schedule service.
Flashes “Lube & Chg Oil” alerts for 2
hours at 25-hour intervals.
6. Lift arm control To move lift arms down, push.
To float, push forward to end.
To move lift arms up, pull.
To curl attachment up, move
to left.
To curl attachment down,
move to right.
IMPORTANT:
• Do not exceed rated operating
capacity when lifting loads. See
page 68.
• In float, weight of attachment
allows attachment to follow
ground contour.
7. Attachment drive
control
To engage attachment drive
in reverse, lift lever release
then push to left.
To engage attachment drive
in forward, lift lever release,
then push right.
IMPORTANT: See attachment drive
foot control on page 22.
8. Ignition switch To start engine, insert key and
turn clockwise.
To stop engine, turn key
counterclockwise.
IMPORTANT: If engine does not start
or stalls, turn key to STOP and then
restart.
NOTICE: Always stop engine at full
throttle.
9. Jumper terminal Use to start engine when
battery is dead.
IMPORTANT: See “Park service
vehicle close to disabled equipment
but do not allow vehicles to touch.” on
page 65.
Item Description Notes