Owner manual

JT60/JT60 All Terrain Operator’s Manual Controls - 33
Left Control Console
2. Add pipe/manual/
remove pipe switch
To select “add pipe”
automated pipeloader
function, press right.
To use manual pipeloader
controls, move to center.
To select “remove pipe”
automated pipeloader
function, press left.
See “Add Pipe” on page 104.
See “Remove Pipe” on page 114.
3. Pipe shuttle stop switch To lower shuttle stop, press
right.
To raise shuttle stop, press
left.
IMPORTANT: Look at pipe row
indicator on drill frame to see which
row shuttles will stop under.
4. Drilling fluid flow
control
To increase flow, turn
clockwise.
To decrease flow, turn
counterclockwise.
5. AutoCarve switch To enable autocarve, press
left.
To deactivate autocarve,
press right.
Two-speed thrust is not allowed in
autocarve mode.
Item Description Notes
c00ic058w.eps
c00ic057w.eps
c00ic056w.eps
c00ic055w.eps