Owner manual

Conduct a Bore - 114 JT60/JT60 All Terrain Operator’s Manual

Remove Pipe

1. Enable automated pipeloader system (automated pipeloader control only). See “Enable Automated

Pipeloader System” on page 103.

2. Clamp pipes. See “Clamp Pipe” on page 98.

3. Break front joint:

• Turn rear wrench counterclockwise to break joint.

• Disengage rear wrench and rotate wrench clockwise.

4. Grip pipe:

5. Separate front joint:

• Slowly rotate spindle counterclockwise and move carriage back to separate pipe.

• When pipe threads are clear, move carriage back slightly and position pipe to be gripped by rear

wrench while breaking rear joint.

Manual Pipeloader Controls Automated Pipeloader Control

• Open grippers.

• Lift pipe off shuttles.

• Extend shuttles to spindle position.

• Close grippers. Leave grippers loose

enough to allow pipe to rotate.

• Lower lifters.

• Press RESUME. Green control cycle light

will come on. Shuttles will extend, grippers

will grip fully and relax open, pipe lifters

will lower, and then green control cycle

light will flash.