Owner manual

FX50 Operator’s Manual Service - 95
100 Hour
CMW
100 Hour
Vacuum System
Change Water Pump Oil
Change oil after the first 25 hours of operation and
every 100 hours thereafter. Change oil more
frequently if working in dusty conditions.
• Drain at drain plug (3) while oil is warm.
• Add NDO at fill (1) until oil is at halfway mark
on sight glass (2).
Lube Blower Bearings
Wipe two zerks (1) clean and lube every 100
hours with HTG. Inject grease into zerk until clean
grease comes out of relief fittings (2).
Location Task Notes
Vacuum
System
Change water pump oil NDO
Lube blower bearings HTG
Debris Tank Check tank mounting bolts
Vacuum
Boom
Check structure
NOTICE: Do not inject grease too quickly. Drive
shaft seal damage could occur.
1
2
3
j36om015w.eps
j36om070w.eps
1
2