Installation Instructions
Sensor EU:
Frequency Band ISM 868 MHz
Transmit Power < 1 mW
Sensor US:
Frequency Band ISM 915 MHz
Transmit Power < 1 mW
The full text of the EU declaration of
conformity is available at the following
internet address:
www.d21s.com/doc
CE:
Hereby, Disruptive Technologies Research AS
declares that the radio equipment type
Sensor EU PN 100111 is in compliance with
Directive 2014/53/EU.
FCC:
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
ISED:
This device complies with the safety
requirements for portable RF exposure in
accordancewith FCC rule part §2.1093 and
KDB 447498 D01.
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic
Development Canada’s licence-exempt
RSS(s). Operation is subject to the following
two conditions:
(1) This device may not cause interference
(2) This device must accept any interference,
including interference that may cause
undesired operation of the device
Cet appareil contient des émetteurs /
récepteurs exemptés de licence conformes
aux RSS (RSS) d’Innovation, Sciences et
Développement économique Canada. Le
fonctionnement est soumis aux deux
conditions suivantes:
(1) Cet appareil ne doit pas causer
d’interférences
(2) Cet appareil doit accepter toutes les
interférences, y compris celles susceptibles
de provoquer un fonctionnement
indésirable de l’appareil
This device complies with the safety
requirements for RF exposure in accordance
with RSS-102 Issue 5 for portable use
conditions.
Le présent appareil est conforme aux limites
d’exposition aux RF conformément au
norme CNR-102 émission 5 pour conditions
d’utilisation portable
Cloud Connector EU 4G:
Frequency Band ISM 868 MHz
Transmit Power < 320 mW
Class 3 (23dBm±2dB) for LTE FDD bands
Class 3 (24dBm+1/-3dB) for WCDMA bands
Class 4 (33dBm±2dB) for EGSM900
Class 1 (30dBm±2dB) for DCS1800
Class E2 (27dBm±3dB) for EGSM900 8-PSK
Class E2 (26dBm±3dB) for DCS1800 8-PSK
Cloud Connector US:
Frequency Band ISM 915 MHz
Transmit Power < 320 mW
The full text of the EU declaration of
conformity is available at the following
internet address:
www.d21s.com/doc
CE:
Hereby, Disruptive Technologies Research AS
declares that the radio equipment type
Cloud Connector EU 4G PN 101505 is in
compliance with Directive 2014/53/EU.
FCC:
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
ISED:
This equipment is exempt from the routine
RF exposure evaluation requirements of
RSS-102. This equipment should be installed
and operated with a minimum distance of
20 cm between the antenna and the user or
bystanders.
Ce matériel n’est pas sujet à l’évaluation
habituelle d’exposition RF selon RSS102. Ce
matériel devrait être installé et exploité en
gardant une distance minimale de 20 cm
entre l’antenne et l’utilisateur ou les
spectateurs.
This device complies with FCC radiation
exposure limits for an uncontrolled
environment. This device shall be installed
and operated with a minimum distance of
20 cm between users or bystanders and the
device.
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic
Development Canada’s licence-exempt
RSS(s). Operation is subject to the following
two conditions:
(1) This device may not cause interference
(2) This device must accept any interference,
including interference that may cause
undesired operation of the device
Cet appareil contient des émetteurs /
récepteurs exemptés de licence conformes
aux RSS (RSS) d’Innovation, Sciences et
Développement économique Canada. Le
fonctionnement est soumis aux deux
conditions suivantes:
(1) Cet appareil ne doit pas causer
d’interférences
(2) Cet appareil doit accepter toutes les
interférences, y compris celles susceptibles
de provoquer un fonctionnement
indésirable de l’appareil