Installation Guide

9/10/2019 Installation Guide – Disruptive Technologies
https://support.disruptive-technologies.com/hc/en-us/articles/360003190014-Installation-Guide 6/22
This will bring up the detail view for the sensor that has just been pressed. Con#rm that the signal strength is high.
If you are not able to identify your sensor or the reported signal strength is weak, go to troubleshooting.
Step 4: Check range at the installation point
If the sensor does not report at the installation point ( ) or the sensor reports in boost mode (b ), we recommend
installing an additional Cloud Connector to ensure coverage.
Bring your sensor to the installation point
Mount the sensor with the non-permanent adhesive included in your kit
Verify the range by pressing the sensor and seeing a response in DT Studio