Users Manual Part 1

24/02/2020 Range Extender – Disruptive Technologies
https://support.disruptive-technologies.com/hc/en-us/articles/360010450159-Range-Extender 3/4
Can't nd what you're looking for?
Let us help you!
CONTACT SUPPORT
Steps
1. Have a clean surface
For the adhesive on the Range Extender to stick, the surface must be clean. Clean if
necessary.
2. Remove the protective layer
Remove the protective layer on the back of the Range Extender.
3. Place the Range Extender
Stick the Range Extender on the surface where the sensor will be mounted.
4. Prepare the sensor
Peel o the adhesive protection on the back of the sensor
5. Align the dots
Make sure that the dot on the sensor aligns with the dot on the Range Extender.
6. Place the sensor
The last step is to glue the sensor to the Range Extender.
The installation is now complete.
Metal surfaces
Please note that mounting the Range Extender directly on a metal surface will not
increase the connection range.
