User manual

DisplayLink Graphics Adapter User Manual

Software Version 7.1

To enable Wake on LAN, check the box to Allow this device to wake the computer

Note: This option will be greyed out if not supported by your PCs USB Host controller or BIOS.

To allow Wake on Magic packet only, also check the option to Only allow a magic packet to wake the computer. This

will be the only way to wake the PC and will over-ride any setting in the Advanced tab.

If the Magic Packet option is NOT checked, further configuration of Wake on LAN can be made under the Advanced

Tab. The options are shown in the screenshot below.

Wake on LAN will wake the PC from an S3 (suspend or sleep) state. It may fail if the PC turns off the USB connection

during S3 on battery power. It will not wake the PC from an S4 (Hibernate) or S5 (Off) state.