User's Manual

Dynamic Communicator Installation Guide 5
Displaydata
Regulatory Information
Regulatory Information
Safety Notices
Take some time to read through the safety notices before installing the Dynamic
Communicator. Please observe all safety markings and instructions when using this
product.
Radio Transmission Regulatory Information
The Dynamic Communicator and the Display (epop) label have been tested to comply
with the following standards.
This product must be installed and used in strict accordance with the instructions given
in the user documentation. The Dynamic Communicator and epop label complies with
the following radio frequency and safety standards:
USA - Federal Communication Commission Interference Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
Canada – Industry Canada Warning Statement
English
"Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication."