User Manual

The following sections detail how to install Bounce Processor and Bounce Manager on a PC
running the Bounce Communicate software (see Bounce Communicate Installation Guide).
In each location that has EPOPs deployed a PC must be set up to manage the network of
EPOPs and perform the communication functions. This PC will also be required to run
Bounce Processor to monitor the data fields specified in Policy Architect and render the
images specified in Template Architect. Bounce Manager is also required to Manage the PC
Configuration
The following section assumes that the user has already installed and set up Bounce
Communicate on a PC as documented in the Bounce Communicate installation guide.
Bounce Processor Installation Guide
To start the installation of Bounce Processor, run BounceProcessorSetup, click Yes on
the following screen below to continue installation process.
The following setup wizard will start, click Next
It is recommended you use the default location, leave as is and click Next
Click Next to confirm your installation