User Manual

DISPLAYS LIMITED

Regulatory Information

Safety Notices

Take some time to read through the safety notices before installing the Bounce Communicator 2. Please observe

all safety markings and instructions when using this product.

Radio Transmission Regulatory Information

The Bounce Communicator 2 and the epop label have been tested to comply with the following standards.

This product must be installed and used in strict accordance with the instructions given in the user documentation. The

Bounce Communicator 2 and epop label complies with the following radio frequency and safety standards:

USA - Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate this equipment.

Europe - CE Declaration of Conformity

We, ZBD Displays Limited of Orchard Lea, Winkfield Lane, Windsor, Berkshire, SL4 4RU,

England, declare under our sole responsibility that the ZBD Bounce Communicator 2 and epop,

to which this declaration relates is in conformity with the following standards and/or other

normative documents:

EN300 220-2 V2.1.1

EN300 220-1 V2.1.1

EN301 489-1 V1.6.1

EN301 489-3 V1.4.1

EN60950-1:2000 A11:4

We, ZBD Displays Limited, hereby declare that this product is in compliance with the essential requirements and

other relevant provisions of Directive 1999/5/EC.

This product can be used in but is not restricted to the following countries:

UK, Germany, Austria, Belgium, Switzerland, Netherlands, Luxembourg, Italy, France, Ireland, Spain, Portugal,

Sweden, Norway, Denmark, Finland, Czech Republic, Hungary, and Greece.