Specifications

Table Of Contents

FCC regulatory compliance statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Warning: changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

This Module complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with a minimum distance of 20cm between the radiator and

your body. This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

Labelling Instruction for Host Product Integrator

Please notice that if the FCC identification number is not visible when the module is installed inside

another device, then the outside of the device into which the module is installed must also display a label

referring to the enclosed module. This exterior label can use wording such as the following: “Contains

FCC ID: 2AKWC-PTR5618PALCI” any similar wording that expresses the same meaning may be used.

§ 15.19 Labelling requirements shall be complied on end user device.

Labelling rules for special device, please refer to §2.925, § 15.19 (a)(5) and relevant KDB publications. For

E-label, please refer to §2.935.

Installation Notice to Host Product Manufacturer

The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or

install module.

The module is limited to installation in mobile application, a separate approval is required for all other

operating configurations, including portable configurations with respect to §2.1093 and difference

antenna configurations.

Antenna Change Notice to Host manufacturer

If you desire to increase antenna gain and either change antenna type or use same antenna type certified,

a Class II permissive change application is required to be filed by us, or you (host manufacturer) can take

responsibility through the change in FCC ID (new application) procedure followed by a Class II permissive

change application.

FCC other Parts, Part 15B Compliance Requirements for Host product manufacturer

This modular transmitter is only FCC authorized for the specific rule parts listed on our grant, host

product manufacturer is responsible for compliance to any other FCC rules that apply to the host not

covered by the modular transmitter grant of certification.

Host manufacturer in any case shall ensure host product which is installed and operating with the module

is in compliant with Part 15B requirements.

Please note that For a Class B or Class A digital device or peripheral, the instructions furnished the user

manual of the end-user product shall include statement set out in §15.105 Information to the user or such

similar statement and place it in a prominent location in the text of host product manual. Original texts as

following: