Display Elektronik GmbH STANDARD OLED/PLED DEP 128064J - Y Product Specification Version : 01 22.08.
History of Version Version 01 DEP 128064J - Y Contents NEW VERSION -2- Date Note 2008/08/22 SPEC.
CONTENTS 1. Numbering System 2. General Specification 3. Absolute Maximum Ratings 4. Electrical Characteristics 5. Optical Characteristics 6. Block Diagram 7. Interface Pin Function 8. Timing Characteristics 9. Power ON / OFF Sequence & Application Circuit 10. Display Control Instruction 11. Reliability 12.
1.
2. General Specification (1) Mechanical Dimension Item Standard Value 128ͪ64 Unit mm mm mm Dot size 41.9*28.0*1.6(MAX) 38.45*20.21 36.45*18.21 0.255(W)ͪ0.255(H) Dot pitch 0.285(W)ͪ0.285 (H) mm Number of dots Module dimension (L*W*H) View area Active area dots mm (2) Controller IC: SSD1325 Controller (3) Temperature Range Operating -40 ~ +70к Storage -40 ~ +85к 3.
5. Optical Characteristics Item View Angle Dark Room contrast Response Time DEP 128064J - Y Min. Typ. Max.
6.
7. Interface Pin Function Pin No. Symbol Level Description Vss 0V VSL ѧ 3 Vcc ѧ Positive OLED high voltage power supply 4 VCOMH ѧ The COM voltage reference pin, this pin should be connected to ground through a capacitor 5 VDD H/L Voltage power supply for logic 6 BS1 H/L Interface select pin 7 BS2 H/L Interface select pin 8 CS# H/L Chip select pin. The driver IC will be selected When CS pin is active low.
8. Timing Characteristics 8-1.
8-2.
8-3.
9. Power ON / OFF Sequence & Application Circuit 9.1 POWER ON / OFF SEQUENCE Power ON sequence: 1. Power ON VDD. 2. After VDD become stable, set RES# pin LOW (logic low) for at least 3us(t1) and then HIGH (logic high). 3. After set RES# pin LOW (logic low ), wait for at least 3us(t2).Then Power ON VCC.(1) 4. After VCC become stable, send command AFh for display ON. SEG/COM wil be ON after 100ms(tAF). Power OFF sequence: 1. Send command AEh for display OFF. 2. Wait until panel discharges completely. 3.
9.1 Application circuit Recommend Components: C1: 2.2uF/25V (0805) C2: 1uF/16V (0603) C3: 4.7uF/25V (TANTALUM or Solid Tantalum 4.
10.
DEP 128064J - Y - 15 -
DEP 128064J - Y - 16 -
DEP 128064J - Y - 17 -
DEP 128064J - Y - 18 -
11. Reliability ϮContent of Reliability Test NO. Items. Specification Applicable Standard High temp. (Non-operation) High temp. (Operation) Low temp. (Operation) High temp. / High. humidity (Operation) 85°C, 240hrs 70°C, 120hrs -40°C, 120hrs 65°C, 90%RH, 120hrs Thermal shock(Non-operation) -40°C ~85°C (-40°C /30min; transit /3min; 85°C /30min; transit /3min) 1cycle: 66min, 100 cycles. —— Vibration Frequency : 5~50HZ, 0.
