Datasheet

DEM 16103 SYH-LY General Specification
VERSION: 1 PAGE: 10
Operation Precautions:
1. The viewing angle can be adjusted by varying the LCD driving voltage Vo.
2. Since applied DC voltage causes electro-chemical reactions, which deteriorate the display, the
applied pulse waveform should be a symmetric waveform such that no DC component remains.
Be sure to use the specified operating voltage.
3. Driving voltage should be kept within specified range; excess voltage will shorten display life.
4. Response time increases with decrease in temperature.
5. Display color may be affected at temperatures above its operational range.
6. Keep the temperature within the specified range usage and storage. Excessive temperature
and humidity could cause polarization degradation, polarizer peel-off or generate bubbles.
7. For long-term storage over 40°C is required, the relative humidity should be kept below 60%,
and avoid direct sunlight.
Limited Warranty
Our LCDs and modules are not consumer products, but may be incorporated by DISPLAY
ELEKTRONIK’s customers into consumer products or components thereof, DISPLAY
ELEKTRONIK does not warrant that its LCDs and components are fit for any such particular
purpose.
1. The liability of DISPLAY ELEKTRONIK is limited to repair or replacement on the terms set
forth below. DISPLAY ELEKTRONIK will not be responsible for any subsequent or
consequential events or injury or damage to any personnel or user including third party personnel
and/or user. Unless otherwise agreed in writing between DISPLAY ELEKTRONIK and the
customer, DISPLAY ELEKTRONIK will only replace or repair any of its LCD which is found
defective electrically or visually when inspected in accordance with DISPLAY ELEKTRONIK
general LCD inspection standard . (Copies available on request)
2. No warranty can be granted if any of the precautions state in handling liquid crystal display
above has been disregarded. Broken glass, scratches on polarizer mechanical damages as well as
defects that are caused accelerated environment tests are excluded from warranty.
3. In returning the LCD/LCM, they must be properly packaged; there should be detailed description
of the failures or defect.