Use & care guide

8
3.3 Waste Bag Removal
a) Open the door and slide out the waste
container.
b) Release the two container latches and lower
front of the container (see picture below).
c) Unbutton bag from container and close by
twisting the bag top. Fasten with stripe or string.
d) Lift and slide bag out from container.
e) See item 2.4 above for attaching new waste
bag into the container.
4. Maintenance
IMPORTANT
Except for cleaning described below, all
service shall only be performed by authorised
service personnel.
4.1 Cleaning
Do not use harsh or gritty cleanser or scouring
pads which may mar the finish of the compactor.
Use a mild detergent solution on these surfaces.
CAUTION: Sharp waste pieces may be on or
around the surfaces to be cleaned. Carefully
remove these objects before wiping down any
surfaces.
When cleaning, the waste container can be
removed from the compactor in the following
manner:
a) Pull out waste container until it stops.
b) Remove screw, one from each of the container
slides (see picture below).
c) Press down on left and right bucket (container)
slide release tabs, while pulling the container out
of the compactor (see picture below).
d) Vaccum and clean cabinet base, track channels
and container – particularly in corners.
e) Wash the cabinet interior with a mild detergent
solution.
f) When finished cleaning the cabinet, install
the waste container by reversing steps b) and
c) above.
2.
3.
1.
BUCKET SLIDE
RELEASE TAB
SCREW